D50 PC Module

Housed microporous polypropylene hollow fiber membrane degassing / contactor module. Degassing water/liquid in benchtop systems, laboratory analyzers and OEM devices.

Polypropylene hollow fiber membrane
1.32m² P60 active membrane surface
Transparent compact PC housing
1/4 BSPP female thread port connections

Characteristic

Membrane Type		P60	P80
Membrane	Material	Polypropylene (natively hydrophobic)
	Pore size	average 0.1 μm
	OD/ID	310/240 μm	530/440 μm
	Burst / Collapse pressure	>5.5 / >3.5 bar
Module	Active Membrane Surface	1.32 m²	0.71 m²
	Priming Volume Shellside	ml	ml
	Priming Volume Lumenside	ml	ml
	Housing Material	PC transparent
	Potting Material / Seals	Polyurethane / x
	Shell pressure	< 5 bar
	Temperature	< 45°C
	Ports	1/4 BSPP
	Dimensions	D54 x 217mm
	Weight	215g

① food grade, no additives PP is used, but due to production small amounts of other materials might be used, please consult us for chemical resistance
② O-ring push in fittings recommended
③ ports are prone to brake in case of fall or excess moment, parallel thread – liquid seal or O-rings are preferred choice

Possible Applications

Gas transfer, microporous hollow fiber membrane is used so gas/liquid or liquid/gas
Gas filtration - gas/solids separation on microfiltration level
Membrane degassing - lab, OEM applications

Applications Notes

Ports are plastic, excessive tightening moments and forces will cause breakage. For parallel thread liquid seal (LOCTITE 5331) is preferred, if joint should be often disassembled O-rings are also suitable. Suitable push-in fittings for pipe d6 or d8mm can be supplied.
Try to avoid temperature shocks, slow change is preferable. For contactor (liquid / gas, degassing) applications temperature gradients might cause condensation inside the pores, wetting and module bleeding. When this happens thorough drying (dry air @50°C at least 24 hours) will restore the module.
No oxidizing chemistry or UV light – PP membrane is very sensitive. For chemical cleaning use standard NaOH / citric acid procedure.
Chemical resistance can be estimated from used materials PP, PC, polyurethane, usually least resistant is potting - polyurethane.